- 12 -
Thread the lap section of the seat-belt around
both seat-belt guides underneath the front of
the First Class Si shell. Make sure that the lap
section of the seat-belt is not twisted and
remove all slack from this section of the belt
before continuing.
6
Fasten the seat-belt across the front of the
First Class Si.
DO NOT try to go around the back of the First
Class Si first – it will not work that way. Feed
the lap section down between the car seat and
the First Class Si.
5
Pull the diagonal section of the seat-belt over
the top of First Class Si. If your seat-belt
appears too short, see the blue box on page 13.
7
Then tighten the seat-belt by first pulling
here...
8
Pull
63513_BBO-604-04_pages 12/16/03, 11:56 AM12
To Next Page
Loading...
