Using the First Class Si
Preparing to install the First Class Si in the car
IMPORTANT -
You must adjust the height of shoulder straps of the harness
to the correct position for your child
BEFORE installing the First Class Si in
the car, as they cannot be adjusted once installed in the car.
Adjusting the Harness
Unfasten the buckle by pressing the red
harness buckle button (a) and place your child
in the seat. Fit the harness around your child.
To fasten the buckle (b); first fit the two upper
sections together as shown, then push them
firmly into the lower section until you hear a
positive click.
2
With one hand, press and hold down the
harness release button. Then, with the other
hand below the chest pads, pull the shoulder
straps forwards.
1
Check the harness is not twisted, then gently
pull the harness up to tighten the lap sections
which are designed to fit low down on your
child's body.
3
Pull the adjuster strap forward making sure the
harness is a comfortable but FIRM fit around
your child. Make sure the harness straps are
not twisted.
4
- 5 -
A
B
63513_BBO-604-04_pages 12/16/03, 11:56 AM5
To Next Page
Loading...
