Britax First Class Si - Looking after the First Class si; Removing the Cover

- 22 -
Looking after the First Class Si
With the First Class Si fully reclined, open the
seat-belt guard at the back of the shell. Pull
the yoke out from behind the seat and unhook
both shoulder straps.
2
Press and hold down the harness release
button. With your other hand below the chest
pads, pull the shoulder straps forward as far as
possible.
1
Pull the cover from the top of the seat so that
you can see the slots in the seat shell. Pull each
shoulder strap and chest pad strap forward
and towards the centre of the shell, easing the
metal tab and straps through the slot.
Then thread them through to the front of the
cover.
3
Unfasten the buckle and remove the comfort
pad. Slide the shoulder straps out of the chest
pads. Gently pull the cover off the seat, easing
the shoulder straps, chest pads, harness buckle
and adjuster strap through the slots in the
cover.
4
IMPORTANT – The cover is a
safety feature. NEVER use the
First Class Si without it.
Removing the cover
63513_BBO-604-04_pages 12/16/03, 11:56 AM22