Britax First Class Si - To Remove the First Class si from the Car

- 13 -
... and then, while holding the First Class Si in
place, pull here.
10
...Thread the belt around the diagonal seat-
belt guide on the side of the seat...
9
The First Class Si should now be secure (seat
shown in upright position for clarity only).
11
IF YOUR SEAT-BELT APPEARS TOO SHORT
1. Is the First Class Si pushed hard against the back of the car seat?
2. On adjustable seats, make sure that the vehicle seat is adjusted as far back as it
will go (such as for a tall passenger).
3. In cars with a seat-belt height adjuster, make sure that it is in its lowest position.
4. For further advice, contact our Customer Services Helpline.
To remove the First Class Si from your car
Simply unfasten the seat-belt and unthread it from the guides.
To stow the recline foot
To return the recline foot to its stored position, simply swing it back into the
underside of the First Class Si. You should hear a click as it disengages from its
locked-open position, and another as it locks into its stowed position. The recline
foot is only securely stowed once you hear this click.
63513_BBO-604-04_pages 12/16/03, 11:56 AM13