Brivis contour Service Manual

Service Manual 32 – Contour 3 Series, Profiler & Advance – Approved Issue 5 Printed 2/13/2014 11:50:17 AM
81
Trident Water Management System (cont.)
Abnormal Operation (cont.)
High Water Level Sensor (failure) - Networker Error 41
High Water Level Sensor
-
Fails to sense or is short
circuit.
Fails to sense:
• Open circuit on High Water Level Sensor after 3 minutes
of detecting water on the Low Water Level Sensor.
Short circuit:
• From start up the Low Water Level Sensor is open circuit
(normal), and the High Water Level Sensor is closed
circuit.
Temporary
High Water Level Sensor Limp Mode Operation
• Water inlet solenoid closes after 3 minutes of the water detected at the Low Water
Level Sensor.
• Water inlet solenoid open when open circuit occurs on Low Water Level Sensor.
• Water inlet solenoid timed to fill for 70 seconds, then closes again.
To rectify this condition, refer to Service Checks section.

Brivis contour Specifications

General

Brand	Brivis
Model	contour
Category	Freezer
Language	English