Back to Contents
Completing the Setup: Broadcom BCM94306MP Mini PCI Card User's
Guide
NOTE—Before you begin, be sure you have the required network information from your network administrator (see Before you begin in
the
Introduction section).
Configuring a network profile (Windows® 2000 environment)
Configuring a network profile (Windows® XP environment)
Configuring a network profile (Windows® 2000 environment)
Before you can connect to a wireless network, you must configure a network profile for that network on your computer using the
BCM94306MP wireless utility. If you purchased your portable computer with the Broadcom BCM94306MP internal 802.11b Mini PCI
card already installed and set up at the factory, follow the network profile configuration instructions provided below. If this is not the
case, first verify that the Broadcom BCM94306MP card has been properly installed in your computer according to the installation
instructions. Then proceed with the following instructions for configuring your network profiles. The instructions explain how to open the
utility and how to use it to configure a network profile.
Opening the utility
1. From the desktop, click the Start button, point to Settings, and click Control Panel.
2. Double-click the BCM94306MP Wireless Utility icon
.
3. If the Wireless Networks tab in the Wireless Configuration box is not on top, click the Wireless Networks tab.
file:///P|/pc/My%20Documents/Working/User%20Guides/94306MP/setup.htm (1 of 25) [11/22/2002 2:16:07 PM]
To Next Page
Loading...
Need help?
General