Broan LP80 - Installation

LP80
n
Installation Guide
Page 3
Punch out Mask
from packaging.
See Step 5.
Installation
Tools needed
• PowerscrewdriverwithaPhillipsbit
• Phillipsscrewdriver
• Wireinsulationstripper
• Wirecutter
Materials needed
• 4"roundmetalductingrecommendedforbestperformance
Use of other ducting is acceptable but may impact performance.
• Roofcaporwallcap(built-indamperrecommended)
• Tapetosealductconnections
• Drywallscrews,sheetmetalscrewsorwire
• Electricalwiringandsuppliesperlocalcoderequirements
1
Remove from Packaging