19
MODEL BW-260
For parts and service, call:
(866) 283-2759
Waldon Equipment, LLC, 201 W. Oklahoma Ave., Fairview, OK 73737
LUBRICATION & MAINTENANCE
1. Grease two steering shaft bearings at the front of the machine every day.
2. The front wheel bearings should be cleaned and packed every six months.
3. The tires on the front and rear of the machine should be kept at 32 psi and should be checked
on a daily basis. When a tire (or tires) needs to be replaced, make sure the replacement tire is
the same type and height as the remaining tire (tires) on the machine. This will keep the sweep-
ing core level.
4. The battery should be checked once a month. Use distilled water only to bring the uid level
up to the required height. Keep battery post and cables clean. Battery requirements are: 12v,
70AH or equivalent.
5. The radiator should be checked for dirt build up every 4 to 8 hours. Use water or compressed
air directed from the engine side of the radiator to remove excess dirt. A mixture of 50% water
and 50% permanent antifreeze should be used in the radiator thru the entire year. Check the
mixture and uid level at least once a week. The uid level should be ½ full on the side of the
over ow tank.
6. Engine oil should be checked once per day. Engine oil type should be: 10w30, MIL-L-21046,
or CD (API specications) equivalent or above. Oil pan capacity is 7 quarts. The oil and oil lter
should be changed after the rst 50 hours and every 150 hours thereafter. All other lters, air,
spin-on fuel and in-line fuel should be changed every 150 hours. Pre-cleaner bowl at the top of
the air inlet tube should be emptied and cleaned daily. Use only diesel fuel.
7. The fuel tank should be drained once a year. The fule tank drain is located in the back of the
fuel tank.
8. The water system (for dust control) should be inspected daily. Clean the water lters, the spray
nozzles and the screen inside the nozzle head daily. Empty tanks daily to prevent algae build
up.
9. The wheel lock-out hub oil level should be checked every three months. Remove the female
hex plug on front or back of the housing to check, the oil level should be up to this hole. If oil
needs to be added use a 10w-40 non-detergent motor oil. Capacity of this hub is approximate-
ly ½ pint or 8 oz.
10. Hydraulic oil should be checked daily. This unit requires the hydraulic tank to be completely or
nearly full for proper function. Oil should be at least to the full mark on the gauge at the right
side of the hydraulic tank. Low hydraulic will result in hesitation of core function and possible
plump cavitation. Change hydraulic oil every six months or as needed. Hydraulic oil type: Dy-
na-Plex 21C Curse or any Hydro-45 viscosity oil. Change both spin-on hydraulic lter (under
good to the left of the engine) and the high pressure lter (under the hood, to the right and
forward of the engine) every three months or every 500 hours, whichever comes rst.
To Next Page
Loading...