6
MODEL BW-260
For parts and service, call:
(866) 283-2759
Waldon Equipment, LLC, 201 W. Oklahoma Ave., Fairview, OK 73737
START UP & PROPELLING
CAUTION
Persons should ride in the seat properly wearing their seat belt whenever the vehicle is moving
or in the vicinity of other moving vehicles. Otherwise, they are much more likely to suffer seri-
ous bodily injury in the event of sudden braking or a collision.
When using the seat belts, observe the following:
• Be careful not to damage the belt webbing or hardware. Take care that they do not get
caught or pinched in the seat.
• Inspect the belt system periodically. Check for cuts, fraying, and loose parts. Damaged parts
should be replaced. Do not disassemble or modify the system.
• Replace entire belt assembly (including bolts) if it has been used in a severe impact.
• Replace belt assembly after 3 years of use and 5 years of manufacture.
This model of broom is hydrostatically driven. Motion is achieved by depressing the foot pedal on
the oor board to the right of center. Letting the foot pedal up will result in a braking action caused
by the hydraulic system. This is the proper method for braking on this machine. The brake pedal
on the left side of the oor board should not have to be used except in cases where the engine has
died or there is a problem with the hydraulic system. To maintain operability, occasional use of brake
system is advised to prevent rusting and seizure of components in place.
WARNING
BEFORE STARTING ENGINE, BE SURE PARKING BRAKE IS SET, LEFT FOOT IS ON THE BRAKE
PEDAL AND RIGHT FOOT DOES NOT CONTACT THE CONTROL PEDAL. FAILURE TO DO SO
COULD CAUSE UNINTENDED MOVEMENT OF VEHICLE RESULTING IN INJURY OR DEATH.
To Next Page
Loading...