7
MODEL BW-260
For parts and service, call:
(866) 283-2759
Waldon Equipment, LLC, 201 W. Oklahoma Ave., Fairview, OK 73737
START UP & PROPELLING
1. Turn the key switch to the start position, all the way to the right. Add fuel is necessary using the
hand operated locking throttle. Release the key switch when the engine starts. Do not use ether
(STARTING FLUID) in this engine, severe engine damage will occur.
2. Use the foot pedal on the oor board to choose the direction of forward or reverse.
3. After the desired direction has been selected, raise engine R.P.M. to about half throttle. Release
parking break. Slowly depress control pedal and adjust the engine to the desired travel speed.
Speed can also be varied by the distance the control pedal is depressed.
4. To stop the engine, turn the key back to the center position. The parking brake must be set
prior to leaving the operator’s seat.
NOTICE
DO NOT REVERSE THE DIRECTION OF TRAVEL WHILE THE BROOM IS IN MOTION. THIS
WILL DAMAGE THE DRIVE COMPONENTS AND VOID THE WARRANTY. THIS TYPE OF OPER-
ATION IS CONSIDERED ABUSE.
To Next Page
Loading...