!
WARNING: Cancer
and Reproductive Harm
www.P65Warnings.ca.gov
16
BROCE FMJ470
MACHINE OPERATION
Prior to initial startup of the machine each day, the following inspection checks must
be performed:
1. Visually inspect the entire machine for damage and uid leaks. Repair
critical items before machine is used.
2. Check all uid levels; engine oil, radiator, and hydraulic reservoir, etc.
Fill uid reservoirs if necessary.
3. Check wheels and tires for excessive wear or damage; also check air
pressure and lug nut tightness.
4. Seat belt, core cover, and rubber rock guard should be installed and serviceable.
5. Lights, windshield wipers, reverse alarm, horn, etc. must be in operating condition.
6. Test brakes before operating this machine. Refer to BRAKES area in the
MAINTENANCE Section in this manual for details.
7. Check water system lters, nozzle screens and cycle system.
Any defects or damage found during this inspection must be repaired before
operating this machine.
MACHINE STARTUP
1.Before starting the engine, be sure the parking brake is set (pull handle up to
vertical position). The brake pedal should be depressed and the right foot is not
on a control pedal.
2. Turn the key switch to the starting position (all the way forward). Add fuel as
necessary using the hand operated throttle near the operator’s right hand. Release
the key switch when the engine starts.
Do not exceed 1500 RPM until the hydraulic uid has warmed up.
To Next Page
Loading...