brondell O2+ Source - Maintenance and Cleaning; Body Maintenance and Cleaning; Filter Maintenance and Replacement; Air Quality Sensor Cleaning

6 MAINTENANCE
6.2 FILTER MAINTENANCE
Make sure to change the lters when the Filter Replacement Indicator noties you. In addition
to changing the lters as needed, you will also want to clean the Mesh Pre-Filter.
To clean the Mesh Pre-Filter, use a vacuum on the low speed to clear any buildup. Do not rinse
or soak the lter in water or any other liquid. The Mesh Pre-Filter is the only lter that can be
cleaned and reused, all other lters need to be replaced.
6.3 AIR QUALITY SENSOR MAINTENANCE
Use a damp swab or soft brush to clean the Air Quality Sensor every 2 months or as needed
to ensure the best performance of the O2+ Source. Follow the below steps to clean the Air
Quality Sensor:
1. Use a soft brush
to clean the vents
above and below
the Air Quality
Sensor.
2. Remove the
protective cover
of the Air Quality
Sensor.
3. Use a damp swab
to clean the Air
Quality Sensor
and vents. Use a
dry swab to dry
them if necessary.
4. Reattach the
protective cover
of the Air Quality
Sensor.
6.1 BODY MAINTENANCE
Regularly clean the inside and outside of the body of the O2+ Source to prevent dust from
collecting on the unit.
1. Wipe away dust with a soft dry cloth from the body of the appliance. Use a damp cloth or
mild cleanser to remove heavy dirt
2. Clean the Air Inlet and the Air Outlet with a soft brush or vacuum cleaner
WARNING: Always unplug the O2+ Source before cleaning or performing other
maintenance. Never immerse the appliance in water or any other liquid.
Do not use harsh chemicals or cleaning agents such as bleach or alcohol to clean any part of
the appliance.
Only the Pre-Filter can be cleaned and reused. The other lters are NOT reusable.
11