13
Fan not working. Unit is not switched on. Ensure the unit is properly plugged
into the outlet.
Motor requires servicing. Contact the Brondell Service Center.
Plastic wrap on lters not removed. Remove the plastic bags and put
lters back in.
Machine is beep-
ing.
Filters need to be changed and the
lter change indicator reset.
Refer to lter replacement
instructions on page 10
Fan speed does
not automatically
adjust when the
Auto Mode is
activated.
Air Quality Sensor is faulty and
alarm will be heard. Air Quality
Indicator will icker in green.
Contact the Brondell Service Center.
Night Mode is activated when
the ambient light is dimmed for
3 minutes.
Press Auto Mode or Fan Speed
Button.
Unit will resume its normal
operation when light sensor detects
ambient light for 5 minutes.
7 TROUBLESHOOTING
CONDITION POSSIBLE CAUSE POSSIBLE SOLUTION
Unit cannot be
switched on.
Front Panel is not placed properly. Remove the Front Panel and
reattach it onto the unit again.
Power plug is not properly
inserted into the electrical outlet.
Unplug the unit and plug it back
into the electrical outlet.
Power plug or cord is damaged. Contact the Brondell Service Center.
Unit is in Lock Mode and stops
operation because exhausted
lters are not replaced.
Clean the Mesh Pre-Filter, replace
HEPA and carbon lters with a new
set, and reset lter change indicator.
Refer to Filter Replacement on page
10 of this manual.
Safety fuse is blown. Replace safety fuse. See Section
6.4 on page 12 for instructions.
To Next Page
Loading...
