The O2+ Source comes with the lters installed, however it is necessary to remove the plastic
wrap on each lter prior to using the appliance. Follow the instructions below to prepare your
O2+ Source lters for use.
1. Grasp the side recesses and gently pull
the top part of the Front Panel towards
you. Then lift the hooks at the bottom
of the panel.
2. Remove all the lters from
the appliance.
3. Remove lters from
plastic wrap material.
4. Put the TrueHEPA and Activated
Carbon lters back into the appliance
in the appropriate order (see Page 3).
NOTE: Make sure that the white tab
on each lter faces you.
3 PREPARING THE FILTERS FOR FIRST USE
6
To Next Page
Loading...
