Bronkhorst®
Instruction Manual FLOW-CONTROL series 9.17.115B12
4
Maintenance
No regular maintenance is required if the FLOW-CONTROL is operated properly, with clean media, compatible with the
wetted materials, avoiding pressure and thermal shocks and vibrations. Units may be purged with a clean, dry and inert gas.
In case of severe contamination, cleaning the inside of the device may be required.
Inexpertly servicing instruments can lead to serious personal injury and/or damage to the instrument or the system it is
used in. Therefore, servicing must be performed by trained and qualified personnel. Contact Mass Flow ONLINE for
information about cleaning and calibration. Mass Flow ONLINE has a trained staff available.
The FLOW-CONTROL is sealed after final adjustment at the factory. Do not open the instrument or loosen the screws.
Breaking the serial number seal will not only invalidate the test pressure, but will also void the warranty.
To Next Page
Loading...
