Site Manual
Alarm 2000 Iss 5
19
Input:
Alarm signal from either the Smoke / Heat Alarms, the MCP or Sprinkler Module.
The alarm input may be normally open contact that switches negative when
closed.
Outputs:
Air-conditioning / heating
1. 24V
DC
to drive high current relay - rated 230V
AC
10Amps
2. set of Air-conditioning / heating voltage free contact
Emergency Lighting –
1. 24V
DC
to drive high current relay - rated 230V
AC
10 Amps
2. Set of Emergency Lighting voltage free contact
Controls:
Heating/Cooling - AUTO/OFF
Emergency Lighting - AUTO/TEST
Indicators:
Heating/Cooling - AUTO/OFF, amber LED
Emergency Lighting - AUTO/TEST, amber LED
Note: The 230V
AC
for the high current relays of the Air conditioning and
the emergency lighting must be wired to a circuit separate to the RFP
mains
To Next Page
