Powering On/Off
Charge the case and earbuds fully before using.
• Remove the earbuds from the case to automatically power them ON. The earbuds’ LED
indicators will flash RED and BLUE. When both earbuds are powered ON at the same
time they will automatically pair to each other after a few seconds.
• Insert the earbuds into the case to automatically power them OFF. The earbuds’ LED
indicators will quickly flash RED when they are powering OFF.
• The earbuds can also be powered ON and OFF by pressing + holding the earbuds’ [Multi]
buttons for 2s. (power ON) or 4s. (power OFF).
Note: The earbuds will automatically
power OFF if they are not paired to a
Bluetooth device after 3 minutes, or if the
paired device is out of Bluetooth range
(10 m / 30 ft) for 3 minutes.
Note: Either earbud can be used
independently.
6
To Next Page
Loading...
