Intended Use | Brose Drive Magnesium housingEN | 16
› The walk assist may only be used when
pushing the e-bike.
» If the e-bike wheels have no ground
contact when using the Walk assist,
there is a risk of injury.
› All components belonging to the Brose
Drive System as well as components
that are mounted on the drive unit (e.g.
chainring, chainring mount, pedals)
must only be replaced with approved
components.
» This protects the drive unit from damage
(e.g. due to overload).
› Do not make any changes to your Brose
Drive System. Never try to increase the
performance of your Brose Drive System.
» You otherwise reduce the life of the
components and risk damaging the
Brose Drive System and your e-bike. In
addition, any kind of manipulation of the
Brose Drive System voids all guarantee
and warranty claims for your e-bike.
Improper use of the system will also
jeopardise your own safety and that of
other road users. Unauthorised changes
to the Brose Drive System could result
in high levels of personal liability or
even the risk of prosecution in the event
of accidents due to manipulation.
› Comply with all national regulations for
the approval and use of e-bikes. These
may differ depending on which country
you are in.
› Remove the battery from the e-bike
before handling it (e.g. before assembly,
maintenance, working on the chain, etc.),
and before transporting or storing it.
» Inadvertent activation of the Brose Drive
System may result in injury.
› Do not let the display and/or control
unit distract you.
If you do not focus solely on traffic, you
risk being involved in an accident. If you
want to make a keypad entry apart from
changing the assist mode and ride data,
stop and enter the appropriate data.
› ATTENTION: There is a risk of burns if the
motor housing is touched. Under extreme
conditions, e.g. sustained high load at low
speed when riding uphill or with a load,
temperatures >60°C can occur on some
parts of the drive.
› NOTE: Familiarise yourself with the
functions of the e-bike and its operation
before starting your first journey.
› NOTE: Keep the user manual with you on
all trips. This will allow you to look up less
frequently needed functions at any time.
2. Intended Use
The drive unit is intended solely for driving
your e-bike and may not be used for other
purposes.
190821_Brose_BDA-DriveMag-Multi.indd 16 21.08.2019 14:35:34
To Next Page
Loading...
