Brose Drive Magnesium housing| Troubleshooting 21 | EN
6. Troubleshooting
WARNING!
Always observe all error information!
NOTE: Have repairs done by a
certified bicycle dealer only.
The fault display indicates fault that the
system can detect independently.
Depending on the type of fault, the drive
may be automatically switched off. Check
the e-bike before making any further trips.
Driving on without the assistance of the drive
is possible at any time.
Depending on the type of fault, the drive
may be automatically switched off. Check
the e-bike before making any further trips.
Driving on without the assistance of the drive
is possible at any time.
The fault display may indicate serious errors
in your Brose Drive system. Errors prevent
the safe operation of the e-bike. There is a
risk of accidents involving personal injury and
damage to the e-bike.
› Stop riding the e-bike. Inform yourself
about the meaning of the error information
and take note of the solution.
› If the meaning of the information is unclear,
stop riding and turn the bike off. Contact
the bike manufacturer, dealer or workshop
for information on the next steps.
Fault information Remedy
Speed sensor fault
Check the speed sensor and position of the spoke
magnet.
Bicycle lighting faults
Turn off the system completely. Then check all
cables and connectors of the front and/or rear
lighting system. Restart the system.
Internal system error identified Restart the system.
If the problem persists, contact an
authorised e-bike dealer.
Restart the system.
If the problem persists, contact an authorised
e-bike dealer.
Brake lighting faults
Turn off the system completely. Then check all
cables and connectors of the brake system. Restart
the system.
Table 04: Fault Information
If you experience any problems using your
Brose Drive System, first check the items
listed in the following table. In many cases,
you can already remedy this yourself.
190821_Brose_BDA-DriveMag-Multi.indd 21 21.08.2019 14:35:35
To Next Page
Loading...
