Brother AX-10 User Manual

SETTING
Pass the tape through the space between the paper After setting the feed spool on the left pin and the
meter (a) and the ribbon guide (b). Set the tape in take-up spool on the right pin, turn the take-up spool
the tape guides on the left and right. counterclockwise until the white tape winds around the
take-up spool.
Set the ribbon into the ribbon guides and then gently Turn the ribbon feed knob counterclockwise to take up
press the cassette down until it clicks into place. any slack. (To remove the cassette ribbon, simply
reverse this procedure.)
To prevent damage and ensure proper installation, Press the motor lock lever toward the platen until it
always handle daisy wheels by gripping the clear plastic clicks into place. Do not force the lever. If you have
tab of the cassette between the thumb and forefinger of difficulty, check again to see that the daisy wheel
your right hand and insert the daisy wheel into the carrier. is set properly.
Make sure that the daisy wheel slips all the way
down into place.
©

Brother AX-10 Specifications

General

Brand	Brother
Model	AX-10
Category	Typewriter
Language	English