Brother AX-10 User Manual

CORRECTION TAPE
Both lift-off correctable ribbon correction tape and To replace the correction tape, first remove the cassette
cover-up nylon correction tape are available. The lift-off ribbon and then remove the used correction tape. Insert
tape removes the character from the paper and the new correction tape then replace cassette ribbon,
cover-up tape leaves the character on the paper but Use the space bar to locate the carrier to the center of
covers it with white ink. the platen. Open the top cover of the typewriter and
hold a new roll of correction tape so the feed spool is in
your left hand and the take-up spool in your right hand.
The rough side of the tape should be toward the platen.
CASSETTE RIBBON
To insert a cassette ribbon, turn the ribbon feed knob
on the cassette counterclockwise to tighten the ribbon.
Then use both hands to slip the back edge of the
cassette onto the carrier.
Note: Use authorized cassette ribbon and correction tape only,
O Failure to do so, will invalidate the guarantee.

Brother AX-10 Specifications

General

Brand	Brother
Model	AX-10
Category	Typewriter
Language	English