Brother BES-1241BC - User Manual

Questions and Answers

D
Dawn HerreraAug 17, 2025
What to do if Brother BES-1241BC Sewing Machine needle keeps breaking?
- D
  Daniel KingAug 17, 2025
  If your Brother Sewing Machine needle is breaking, check these points: 1. Ensure the needle is correctly attached (direction, height, etc.). 2. Check if the needle is bent. 3. Verify that the rotary hook is correctly attached. 4. Confirm the timing is set correctly. 5. Check for backlash in the needle bar case. 6. Ensure the rotary hook stopper is correctly attached. 7. Verify the needle size is correct and the tip is sharp. 8. Confirm the thread passes through the hole center of the presser foot.
J
James RogersAug 23, 2025
Why is my Brother BES-1241BC operation abnormal?
- T
  Toni NelsonAug 25, 2025
  If the Brother Sewing Machine operation is abnormal, check the following: * See if any set screw of the rotary encoder is loosened. * See if any set screw of the machine pulley is loosened. * See if any set screw of the machine motor pulley is loosened. * See if the embroidery data is normal. * See if the XY carriage belt is loosened.
L
Luke AnthonyAug 29, 2025
What to do if Brother BES-1241BC not embroidered properly?
- M
  Marilyn GuzmanAug 29, 2025
  If your Brother Sewing Machine isn't embroidering properly, try these checks: * Make sure that the material edge isn't caught in the machine. * Confirm that the material is stretched properly. * Ensure that the thread tension is proper. * Verify that the lower thread comes out smoothly.
N
Nancy LeeSep 4, 2025
How to solve needle interference with embroidery hoop on Brother BES-1241BC?
- R
  Rebecca WallaceSep 4, 2025
  To address needle interference with the embroidery hoop on your Brother Sewing Machine: * Check if the embroidery hoop is too small. * Check the size and needle start position in the sewing data.
J
Jasmine CamposNov 10, 2025
How to fix thread breakage on Brother Sewing Machine?
- K
  Kayla StephensonNov 10, 2025
  To resolve thread breakage on your Brother Sewing Machine, consider the following: * Ensure the machine is threaded correctly. * Verify the thread tension isn't too high. * Check for clogs in the rotary hook assembly. * Make sure there's thread in the bobbin. * Inspect the needle for bending or damage. * Examine the needle plate, rotary hook, and bobbin case for rough edges or flaws. * Confirm the needle is installed correctly. * Ensure the presser foot contacts the material. * Verify the thread thickness and needle size are appropriate. * Use thread with a left-hand twist instead of a right-hand twist. * Check for adhesive on the needle. * Ensure the material tension isn't too weak. * Check for excessive play between the outer and inner rotary hooks. * Confirm...