www.brother.com
Brother
Embellishment
Feet
18
Binding Foot
Binding Foot
Attaches bias tape with widths less than 7 mm (1/4 inch) using straight,
zigzag or decorative stitches.
1. Before attaching the presser foot, insert the bias tape into the funnel guide to match the
tape edge to the guide side.
2. Pull the tape from the rear of the presser foot.
3. Snap on the presser foot.
4. Adjust the needle position so that the needle lines up to the edge of the bias tape.
Hint: If the needle does not position properly on the bias tape, loosen the position knob on
the foot to slide the guide to the left or right.
Brother
Embellishment
Feet
17
Go decorative.
Personalize your projects with Brother Embellishment Feet.
SA109
All Brother home-use sewing machines
Innov-is Project Book
(See page 41 for details.)
Baby Vest
To Next Page
Loading...
Need help?
General
