www.brother.com
Brother
Cover Stitch
Feet
78
Top Stitching Foot Set
Hemming Set
Finishes hems easily and quickly. The
stitches are always smooth.
1. Set up your machine for a cover stitch, with
the LC1 presser foot included in the machine.
2. Attach the hem positioning plate A/B to the
hemming attachment, and attach it to your
machine.
3. Fold fabric and set it into the guide.
4. Sew.
Brother
Cover Stitch
Feet
77
Bias Tape Binding Set
Hemming Set
Bias Tape Binding Set
Attaches 6 or 12 mm (approx. 1/4 to 1/2 inch) bias tapes as folding
them.
Attaching 6 mm (approx. 1/4”) bias tape:
Use the small bias tape sliding plate with the LC2 presser foot.
Attaching 12 mm (approx. 1/2”) bias tape:
Use the large bias tape sliding plate with the LC1 presser foot (included with your Cover
Stitch).
1. Set up your machine for a chain stitch, the center needle.
2. Insert the tab on the bias tape attachment into the front cover slot.
3. Set the bias tape though the holder (cut the end of fabric pointed so that it is easily set
through the holder).
4. Sew as holding the fabric lightly with a tweezers.
SA224CV
SA221CV
SA226CV
Top Stitching Foot Set
Use included presser foot to top stitch with 3 or 6 mm (approx. 1/8 or
1/4 inch) wide cover stitch.
1. Set T1/T2 presser foot.
2. Set up your machine for a cover stitch, with 3 or 6 mm wide cover stitch.
3. Open the seams.
4. Align the fabric joint and the groove of the presser foot, and sew.
To Next Page
Loading...
Need help?
General
