Chapter 5
40
Enhance Scenery 5
Enhance Scenery is best used for adjusting
landscape photographs. It highlights green
and blue areas in your photo, so that the
landscape looks more sharp and vivid.
a Make sure you have put the memory
card or USB Flash memory drive in the
correct slot.
Press (PhotoCapture).
b
Press
a
or
b
to choose
Photo Effects
.
Press OK.
c Press d or c to choose your photo.
Press OK.
d Press a or b to choose
Enhance Scenery.
Press OK.
e Do one of the following.
Press OK if you do not want to
change any settings.
Press a or b to adjust the effect level
manually. Press OK when you have
finished.
f Press + or - repeatedly to enter the
number of copies you want.
g Do one of the following.
Press OK and change the print
settings. (See page 44.)
If you do not want to change any
settings, press Colour Start to print.
Remove Red-Eye 5
The machine detects eyes in your photos and
will remove red-eye from your photo.
Note
There are some cases when red-eye may
not be removed.
• When the face is too small.
• When the face is turning too far up,
down, left or right.
a
Make sure you have put a memory card or
USB Flash memory drive in the correct slot.
Press (PhotoCapture).
b
Press
a
or
b
to choose
Photo Effects
.
Press OK.
c Press d or c to choose your photo.
Press OK.
d
Press
a
or
b
to choose
Remove Red-Eye
.
Press OK.
When
Remove Red-Eye
is successful,
the photo after effect is shown. The
adjusted part is shown in a red frame.
When
Remove Red-Eye
is unsuccessful,
Unable to Detect.
is shown.
Note
Press a to try Remove Red-Eye again.
•
When
Remove Red-Eye
is successful,
the photo after effect is shown. The
adjusted part is shown in a red frame.
•
When
Remove Red-Eye
is unsuccessful,
Unable to Detect.
is shown.
e Press + or - repeatedly to enter the
number of copies you want.
f Do one of the following.
Press OK and change the print
settings. (See page 44.)
If you do not want to change any
settings, press Colour Start to print.
To Next Page
Loading...
