Brother DCP-4020C - Changing the Default Settings

WALK-UP PHOTOCAPTURE CENTER
™
6 - 16
Changing the default settings
You can adjust the Print Quality, Print Size, Brightness, Contrast,
Colour Enhance and Scan to Card settings, that are shown in the
chart. These settings will remain set until you change them again.
Press
Menu/Set
,
3
, followed by the number of the setting you want
to change. (See details on the following pages.)
Submenu Menu
Selections
Options (1) Options (2) Factory Settings
1
.
PRINT QUALITY
—
NORMAL
—
FINE
FINE
PHOTO
2
.
PRINT SIZE
—
13×9CM
—
15×10CM
15×10CM
18×13CM
20×25CM
3
.
BRIGHTNESS
—- +—- +
- +
- +
- +
- +
4
.
CONTRAST
—- +—- +
- +
- +
- +
- +
5
.
COLOUR
ENHANCE
ON 1
.
WHITE BALANCE
- + (- +)
- +
- +
- +
- +
2
.
SHARPNESS
- + (- +)
- +
- +
- +
- +
3
.
COLOUR
DENSITY
- + (- +)
- +
- +
- +
- +
OFF
——
OFF
6
.
SCAN TO CARD
(See
How to scan
using Windows
®
on
page 9-1.)
—
PDF
—
PDF
JPEG