Brother DCP-9270CDN - Tray Selection

Chapter 4
14
d Press d or c to display Duplex Copy.
Press Duplex Copy.
e Press d or c to display the following
layout options:
2sidei2side,
1sidei2side LongEdgeFlip,
2sidei1side LongEdgeFlip,
1sidei2side ShortEdgeFlip,
2sidei1side ShortEdgeFlip,
Off
Press the option you want.
f If you do not want to change additional
settings, press Mono Start or Colour
Start.
Tray selection 4
You can temporarily change the Tray Use
option for the next copy.
a Press (COPY).
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Tray Use.
Press Tray Use.
e Press MP>T1, MP>T1>T2
1
, T1>MP,
T1>T2>MP
1
, Tray#1 Only,
Tray#2 Only
1
or MP Only.
1
T2 and Tray#2 Only appears only if the
optional lower tray is installed.
f If you do not want to change additional
settings, press Mono Start or Colour
Start.
Note
To change the default setting for Tray
Use, see Tray Use in copy mode in
Chapter 2 of the Basic User's Guide.