Brother DCP-9270CDN - Adjusting Colour (Saturation)

Chapter 4
18
h Press Mono Start or Colour Start. The
machine scans the other side of the card
and prints the page.
Note
When 2 in 1 ID Copy is chosen, the
machine sets the quality to Photo and the
contrast to +2.
Adjusting Colour (Saturation)4
You can change the default setting for colour
saturation.
a Press (COPY).
b Load your document.
c Enter the number of copies you want.
d Press d or c to display Color Adjust.
Press Color Adjust.
e Press Red, Green or Blue.
f Press d to decrease or c to increase the
colour saturation.
Press OK.
g Repeat steps e and f if you want to
adjust the next colour. Press .
h If you do not want to change additional
settings, press Mono Start or Colour
Start.