Brother DCP-J525W - Loading Paper and Media; Loading Standard Paper Types

19
For Wireless Network Users
Wireless Network
j Enter the Network Key you wrote down in
step 11-a on page 15 and then enter the key
again in Confirm Network Key, then click
Next.
k Click Next. The settings will be sent to your
machine.
l Disconnect the USB cable between the
computer and the machine.
m Click Next to continue to install MFL-Pro Suite.
Wireless setup is now complete. A four
level indicator is shown at the top of the
LCD which displays the wireless signal
strength of your access point/router.
To install MFL-Pro Suite, continue to
step 14-e on page 25.
Now go to
Page 25
Note
If your network is not configured for
Authentication and Encryption, the following
screen will appear. To continue configuration,
click OK and go to k .
Note
• The settings will remain unchanged if you click
Cancel.
• If you want to manually enter the IP address
settings of your machine, click Change IP
Address and enter the necessary IP address
settings for your network.
• If the wireless setup failure screen appears,
click Retry and try starting from step i again.