~
Over
looper
mechanism
(1)
Remove
the
three screws and the thread guide bracket
0.
(2)
Loosen
the
screw, and remove over looper thread take-up
(R)
@)
from
the
over looper shaft @. (Under
looper
thread take-up
(R)
0
will
come off.)
(3)
Remove
the
five screws,
the
inside cover@), and
the
looper thread guide
(9.
(4)
Loosen
the
screw, and remove
the
over looper@) from
the
over looper holder & .
(5)
Loosen
the
bolt
for
the
over looper arm
@).
(6)
Remove
the
two
screws,
the
over looper mechanism assembly
4Ii>
from
the
over looper shaft@.
NOTE:
The guide bush positioning plate
{I)
has
already been adjusted before shipping.
Do
not
remove
it
unless
it
is
necessary.
-34-
To Next Page
