Brother GTX - Page 13

OKOK
MENUMENU
0
MIN
STORAGE
TEMPERATURE
40
MAX
C
°
°
13 13
Switch on the printer and insert a USB stick
Go to the menu: Maintenance > Log copy to USB >
Depending on the length of time you intend on not using the printer will determine which
run down procedure to follow:
NEVER turn the printer OFF, otherwise, the printer may be damaged.
• Clean the Nozzle Guard, Wiper Blade and Exhaust Cap
• Empty the waste ink in the Waste Ink tank
• Check the amount of Cleaning Solution in the Cleaning Solution tank is lled to
the maximum level
• Agitate the white ink if a white ink cartridge stirring message is displayed on the
operation panel screen
• Print out a Nozzle Check pattern
• Clean the Nozzle Guard, Wiper Blade and Exhaust Cap
• Empty the waste ink in the waste ink tank
• Check that the amount of Cleaning Solution in the Cleaning Solution tank is lled to the
maximum level
• From the menu, select [Maintenance] > [White Ink Pause Mode] > [Enable] Then Press
• Remove the White ink cartridges and replace both White Ink Pouches with Maintenance
Pouches [GCX-4S70]. Insert the White Ink Cartridges back into the printer. Then Press
Note: When you need to print with white ink again, you will need to Disable White Ink Pause Mode
• Empty the waste ink in the waste ink tank
• From the menu, select [Maintenance] > [White Ink Pause Mode] > [Disable]. Then Press
• Remove the White ink cartridges and replace both Maintenance Pouches with brand new White
Ink Pouches. Insert the White Ink Cartridges back into the printer. Then Press
UP TO 2 WEEKS
FOR MORE THAN 2 WEEKS (Use White ink Pause mode)
WHEN YOU'RE NOT USING THE PRINTER FOR A LONG PERIOD OF TIME
INK & SOLUTIONS STORAGE
HOW TO EXTRACT A LOG FILE FROM THE PRINTER
CMYK & White inks, Cleaning Solution, Maintenance Solution &
Pre-Treatment Solution should be stored at a temperature range
between 0° and 40°.
Do not store consumables outside this temperature range
OKOK
MENUMENU
OKOK
MENUMENU
OKOK
MENUMENU
OK
MENU