CHAPTER 2 PCL - 7
1. COMMAND LIST
Control Codes 11
Escape sequences 12
Esc&k#G Line termination 12
Esc&s#C End-of-line wrap 13
EscY Display function mode 13
EscZ Display function mode 13
Environments 14
Job Control 15
Esc&l#A Page size 15
Esc&n# Media type selection 16
Esc&l#G Output tray 16
Esc&l#H Paper source 18
Esc&l#U Left long-edge offset registration 21
Esc&l#Z Top offset registration 21
Esc&l#S Simplex/duplex printing 22
Esc&a#G Paper side selection 22
Esc&l1T Job separation command 22
EscE Reset 22
EscCR FD Reset to factory default settings 23
EscCR!#R Reset to user settings 23
Escz Printer self test 23
Esc%-12345X Exit current emulation mode 23
EscCR## Change emulation mode 23
The Page 25
Esc&u#D Unit of measure 28
Esc&a#L Setting the left and right margins 28
Esc&a#M Setting the left and right margins 28
Esc9 Resetting the horizontal margins 29
Esc&l#E Setting the top margin 29
Esc&l#C Setting the vertical motion index (VMI) 30
Esc&k#H Setting the horizontal motion index (HMI) 30
Esc&l#D Setting line spacing 31
Esc&l#F Text length 31
Esc&l#P Page length 32
Esc&l#L Perforation skip 32
Esc&a#R Vertical cursor positioning -rows 33
Esc*p#Y Vertical cursor positioning - units 33
Esc&a#V Vertical cursor positioning - decipoints 33
Esc&a#C Horizontal cursor positioning - columns 34
Esc*p#X Horizontal cursor positioning - units 34
Esc&a#H Horizontal cursor positioning - decipoints 35
Esc&f#S Using the cursor position stack 35
Esc= Half line feed 36
Esc&l#O Logical page orientation 36
Esc&a#P Text direction 36
Using fonts 38
Esc(3@, Esc)3@ Selecting the default fonts 40
SI, SO Switching between the primary and secondary font 40
Esc*c#R Symbol set ID code command 43
Esc(f#W Define symbol set 43
Esc*c#S Symbol set control command 45
Esc(symbol set ID Select the symbol set 45
Esc(s#C, Esc)s#C Select the symbol set 46
Esc(s#P, Esc)s#P Selecting the type of character spacing 47
To Next Page
Loading...
