What does a constant yellow lamp indicator light mean on my Brother Projection TV?
If the lamp indicator light on your Brother Projection TV is a constant yellow, it means the lamp may fail soon. It is recommended to purchase a new lamp.
What does a constant red lamp indicator light mean on my Brother Projection TV?
If the lamp indicator light on your Brother Projection TV is a constant red, turn the TV off for at least 2 minutes, then turn it back on. If the light remains red, the lamp has failed and needs replacement.
Why can't NetCommand learn device keys on my Brother Projection TV?
If the NetCommand on your Brother Projection TV is unable to learn specific device keys, it could be because the device does not use IR format for its remote control signal (ITT and RF formats cannot be learned). Room lighting may also affect the signal, so try having the remotes very close (6 inches or less) to the TV during Learning. If using a Mitsubishi remote control, make sure the slide switch is not set to the TV position. Note that some device key functions may not be learnable by NetCommand. If the signal from the remote control may not be strong enough, insert fresh batteries and try Learning again.
Why can't I get certain channels on my Brother Projection TV?
If you cannot access a channel on your Brother Projection TV, try using the number keys instead of the CHANNEL up/down buttons. Also, ensure the channel is in memory. Check that the TV is set to the correct device or antenna for that channel by pressing the DEVICE button. Make sure the V-Chip lock is off, and if tuning to digital channels, ensure the physical channel is in memory.
How to find CableCARD ID on Brother Projection TV?
If your cable provider needs information to start CableCARD™ service for your Brother Projection TV, press TV MENU on the remote control, then enter 999 to display the Host ID and CableCARD™ ID information.
Why does my Brother Projection TV keep turning off and blinking?
If your Brother Projection TV turned itself Off and the light on the front panel started to blink, it might be due to a momentary power fluctuation. Wait for the green light to stop flashing, then turn it on again. If it continues, use the System Reset button. If it happens frequently, consider using an AC line power conditioner/surge protector. It could also be due to an unusual digital signal, so waiting for the light to stop flashing before turning the TV back on is advisable.
What to do if there is no sound on my Brother Projection TV?
If there is no sound from your Brother Projection TV even when the volume is turned up, check the audio source in the Device Menu. Ensure that the MUTE button is not activated. Verify that the TV’s “Listen to:” setting is not set to SAP, and confirm that the “TV Speakers” setting is On in the Audio/Video menu.
Why does my Brother Projection TV take so long to respond to channel changes?
If your Brother Projection TV takes several seconds to respond, especially on digital channels, this is normal. To speed things up, press ENTER after entering a channel number. Also, use a 4-digit number for over-the-air digital channels or a 6-digit number for cable digital channels.
General| Printer Type | Color Laser Printer |
|---|---|
| Print Speed (Black) | 20 ppm |
| Print Speed (Color) | 20 ppm |
| Print Resolution | 2400 x 600 dpi |
| Duplex Printing | Manual |
| Paper Input (Standard) | 250 sheets |
| Paper Capacity | 250 sheets |
| Connectivity | USB |
| Max Paper Size | A4 |
| Interface | USB |
To Next Page
