R
Robert WyattAug 30, 2025
What to do if my Brother Laser printer says NO TONER?
- BBrent StephensonAug 31, 2025
If your Brother Laser printer displays 'NO TONER', open the front cover, then install the toner cartridge.
To Next PageTo Next PageWhat to do if my Brother Laser printer says NO TONER?
If your Brother Laser printer displays 'NO TONER', open the front cover, then install the toner cartridge.
How to resolve 'Cartridge Error' on Brother HL-2240 Printer?
If you are getting a 'CARTRIDGE ERROR' on your Brother printer, make sure that the drum unit and toner cartridge assembly is installed properly.
Why is my Brother Laser printer not feeding paper from the manual feed slot?
If your Brother Laser printer is not feeding paper from the manual feed slot, put only one sheet of paper in the manual feed slot. Also, make sure that you have chosen Manual in Paper Source of the printer driver.
Why does my Brother HL-2240 Printer say 'No Paper T1'?
If your Brother printer displays a 'No Paper T1' error, it could be due to several reasons. The paper tray might be empty or not correctly installed; if it’s empty, add a new stack of paper and press Go. Even if there is paper, ensure it is straight and not curled—straighten if necessary. Try removing the paper, turning the stack over, and placing it back in the tray. Reduce the amount of paper in the tray. Also, verify that the paper meets Brother’s recommended specifications and that you've loaded the same size paper selected in the driver settings. If the problem persists, the paper pick-up roller may be dirty and needs cleaning.
What should I do if my Brother Laser printer says 'Toner Low'?
If your Brother Laser printer indicates 'TONER LOW', it's time to buy a new toner cartridge and have it ready for when the 'REPLACE TONER' status is indicated.
Why is my Brother Printer showing a paper size error?
If your Brother printer is displaying a paper size error, it could be due to: * The registration front actuator catching. Correct its position. * The main PCB might be faulty and need replacement.
How to delete the "Replace Toner" message on a Brother HL-2240 Printer after replacing the toner?
If you're still seeing the "Replace Toner" message on your Brother printer after replacing the toner, consider the following: * The new toner actuator might be catching; correct its position. * Check and reconnect the harness of the Panel PCB if there's a connection failure. * The Panel PCB assembly or Main PCB assembly might need replacement.
Why does the paper slide off the output tray of my Brother Laser printer?
If the paper slides off the top output tray of your Brother Laser printer, lift up the output tray support flap 1. If the paper curls and slides off, lift up the output tray support flap 2.
What does 'Toner Low' mean on my Brother HL-2240?
If your Brother printer is indicating 'TONER LOW', buy a new toner cartridge and have it ready for when the 'REPLACE TONER' status is indicated.
What to do if my Brother HL-2240 Printer has paper jam at paper tray and front cover section?
If you're experiencing paper jams in your Brother printer's paper tray and front cover area, it could be due to several reasons. The paper edge actuator or registration front actuator might be catching. Try correcting the position of the paper edge actuator or registration front actuator. Another cause might be worn out paper feeding kit, which requires replacement. Also, check the harness connection of the registration front/rear sensor PCB ASSY and reconnect it if necessary. In some cases, the low voltage power supply PCB ASSY or the main PCB might be faulty and require replacement. Finally, the registration front/rear sensor PCB ASSY may be failing, requiring a check of the registration front and rear sensor performance. If a problem is detected, replace the regist frame ASSY.
General| Color | No |
|---|---|
| Maximum resolution | 2400 x 600 DPI |
| Economical printing | Yes |
| Time to first page (black, normal) | 8.5 s |
| Print speed (black, normal quality, A4/US Letter) | 24 ppm |
| Maximum internal memory | - MB |
| Sound power level (standby) | 31 dB |
| Sound pressure level (printing) | 53 dB |
| Total input capacity | 250 sheets |
| Total output capacity | 100 sheets |
| Total number of input trays | 1 |
| Custom media width | 76.2 - 216 mm |
| Maximum print size | 216 x 356 mm |
| Custom media length | 116 - 406.4 mm |
| Paper tray media types | Bond paper, Plain paper, Recycled paper |
| Paper tray media weight | 60 - 105 g/m² |
| ISO A-series sizes (A0...A9) | A4, A5, A6 |
| ISO B-series sizes (B0...B9) | B5, B6 |
| Multi-purpose tray media types | Bond paper, Envelopes, Heavyweight paper, Labels, Plain paper, Transparencies |
| Maximum ISO A-series paper size | A4 |
| Multi-Purpose Tray media weight | 60 - 163 g/m² |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (standby) | 65 W |
| Power consumption (printing) | 495 W |
| Power consumption (PowerSave) | 0.9 W |
| Maximum duty cycle | - pages per month |
| Page description languages | GDI |
| Sustainability certificates | ENERGY STAR |
| Package weight | 8000 g |
| Standard interfaces | USB 2.0 |
| Mac operating systems supported | Mac OS X 10.4 Tiger, Mac OS X 10.5 Leopard, Mac OS X 10.6 Snow Leopard, Mac OS X 10.7 Lion |
| Windows operating systems supported | Windows 2000, Windows 2000 Professional, Windows 7 Home Premium, Windows 7 Professional, Windows 7 Professional x64, Windows 7 Starter, Windows 7 Starter x64, Windows 7 Ultimate, Windows 7 Ultimate x64, Windows Vista Business, Windows Vista Business x64, Windows Vista Home Basic, Windows Vista Home Basic x64, Windows Vista Home Premium, Windows Vista Home Premium x64, Windows Vista Ultimate, Windows Vista Ultimate x64, Windows XP Home, Windows XP Home x64, Windows XP Professional, Windows XP Professional x64 |
| Product color | Black |
Weight and Dimensions| Dimensions (WxDxH) | 368 x 360 x 183 mm |
|---|
