Why is the screen black when viewing digital channels on my Brother Projection TV?
If the screen is black when trying to view digital channels or an IEEE 1394 device on your Brother Projection TV, the PerfectColor™ color balance has been incorrectly set. Use the Advanced menu to reset the color balance.
Why does my Brother Projection TV take so long to respond to channel changes?
If your Brother Projection TV takes several seconds to respond, especially on digital channels, this is normal. To speed things up, press ENTER after entering a channel number. Also, use a 4-digit number for over-the-air digital channels or a 6-digit number for cable digital channels.
What to do if there is no sound on my Brother Projection TV?
If there is no sound from your Brother Projection TV even when the volume is turned up, check the audio source in the Device Menu. Ensure that the MUTE button is not activated. Verify that the TV’s “Listen to:” setting is not set to SAP, and confirm that the “TV Speakers” setting is On in the Audio/Video menu.
Why does my Brother Projection TV keep turning off and blinking?
If your Brother Projection TV turned itself Off and the light on the front panel started to blink, it might be due to a momentary power fluctuation. Wait for the green light to stop flashing, then turn it on again. If it continues, use the System Reset button. If it happens frequently, consider using an AC line power conditioner/surge protector. It could also be due to an unusual digital signal, so waiting for the light to stop flashing before turning the TV back on is advisable.
Why can't I record using the REC button on my Brother Projection TV?
If the REC button is not working, or, on the Transport menu the record key is grayed out and not available on your Brother Projection TV, it may be because the device does not support recording, such as a DVD player. Recordings cannot be initiated from the Transport menu when using an IEEE 1394 device. Press REC instead to display the Record menu.
Why is my Brother Projection TV screen blue when I select a device?
When a device is selected from the Device Selection menu on your Brother Projection TV, and the screen is blue (no signal source), make sure the selected device is turned on. From the Edit NetCommand® menu select Review setting. Verify that the inputs are actually connected to the TV. If they are not, either change the physical connections on the back panel, or select the Change setting on the Edit NetCommand menu to change the TV NetCommand’s settings for the connection. You may also need to begin play of the VCR.
What to do if my Brother Projection TV is frozen and won't turn off?
If the TV functions on your Brother Projection TV do not respond to the remote control or to the front panel control and will not Power Off, use the System Reset button.
How to fix rolling white lines on my Brother Projection TV when VCR is stopped?
When viewing a stopped VCR on your Brother Projection TV, if white lines are rolling on the screen, turn off video mute for the VCR. Alternatively, begin playing the tape or change the VCR input to the antenna input.
Why is there no picture in PIP on my Brother Projection TV?
If PIP does not display a picture on your Brother Projection TV, ensure that the V-Chip lock is off. Also, note that not all inputs can be displayed as a PIP.
What does a flashing yellow lamp indicator light mean on my Brother Projection TV?
If the lamp indicator light on your Brother Projection TV is flashing yellow, it indicates that the lamp cover door is open or the lamp cartridge is not secure.
General| Printer Type | Color Laser Printer |
|---|---|
| Print Speed (Black) | 20 ppm |
| Print Speed (Color) | 20 ppm |
| Print Resolution | 2400 x 600 dpi |
| Duplex Printing | Manual |
| Paper Input (Standard) | 250 sheets |
| Paper Capacity | 250 sheets |
| Connectivity | USB |
| Max Paper Size | A4 |
| Interface | USB |
To Next Page
