3-77
Confidential
9.23 Develop Release Drive Unit
(1) Release the wiring of the Develop release drive unit.
(2) Remove the three Taptite bind B M4x12 screws from the Develop release drive unit.
Release the three Hooks and remove the Develop release drive unit from the Main body.
Fig. 3-93
Harness routing: Refer to “ Develop Release Drive Unit, Develop Release Sensor PCB
ASSY, Toner/New Sensor PCB ASSY”
Taptite bind
Hook
Develop release drive unit
Main body
Hook
B M4x12
<Left side>
To Next Page
Loading...
