Brother HL-L9200CDW - 1.3.8 Operational check of sensors (Function code 32)

5-13
Confidential
1.3.8 Operational check of sensors (Function code 32)
<Function>
This function is used to check that the sensors are operating normally.
<Operating procedure>
The table below summarizes the displays on the LCD, sensor names and detection status.
*1
When two LT are installed, “T4” is displayed. In other cases, “C2” is displayed.
Model without touch panel
Model with touch panel
(1) Press the or key to display
“MAINTENANCE 32” on the LCD in the
initial state of the maintenance mode.
Then, press the OK key.
“C1C2MPCVRCPO****” is displayed on
the LCD. When the T2 paper tray unit is
not installed, “C1**MPCVRCPO****” is
displayed.
(2) Pressing the Go key displays the next
group.
(1) Press the 3 and 2 keys in this order in
the initial state of the maintenance
mode. “C1C2MPCVRCPO****” is
displayed on the LCD. When the T2
paper tray unit or T3 paper tray unit is
not installed, “C1**MPCVRCPO****” is
displayed.
(2) Pressing the Mono key displays the
next group.
LCD Sensor names Detection status (displayed/not displayed)
C1 T1 paper feed sensor Paper tray 1 installed/not installed
C2
*1
T2 paper feed sensor T2 paper tray unit installed/not installed
T4
*1
T4 connect detection (Main PCB) T4 paper tray unit not connected/connected
MP MP paper empty sensor MP tray paper not detected/detected
CV Front cover sensor Front cover closed/open
RC Back cover sensor Back cover closed/open
PO Eject sensor Paper not detected/detected
L2 T2 plate origin sensor Plate down of T2 paper tray unit/
Plate up of T2 paper tray unit
T2
T2 connect detection (Main PCB) T2 paper tray unit connected/not connected
MR MP registration front sensor Paper not detected/detected
RM Registration front sensor Paper not detected/detected
RA Registration rear sensor Paper not detected/detected
FW Waste toner sensor Waste toner detected/not detected
NK New toner sensor (Black) OFF/ON
NC New toner sensor (Cyan) OFF/ON
NM New toner sensor (Magenta) OFF/ON
NY New toner sensor (Yellow) OFF/ON
KC Toner sensor (Black) Toner detected/not detected
CC Toner sensor (Cyan) Toner detected/not detected
MC Toner sensor (Magenta) Toner detected/not detected
YC Toner sensor (Yellow) Toner detected/not detected