5-20
Confidential
If an error occurs while executing Function code 41, error items below are displayed on the
LCD. Press the Cancel key for the model without a touch panel and the X key for the model
with a touch panel, and the machine returns to the initial state of the maintenance mode.
Then, take a measure.
Restoration Procedure
Restore methods
“Import PI” for restoring only user setting information
“Import ALL” for restoring all backup data including machine information
LCD Cause
USB Mem used The USB flash memory is being used by another operation.
Insert USB Mem No USB flash memory is inserted.
No file The file name is invalid or no “BROTHER” folder exists.
USB Mem Error USB flash memory error
Write Error The USB flash memory does not have enough space.
Model without touch panel
Model with touch panel
(1) Insert the USB flash memory containing
the backup data into the slot of the
machine in the initial state of the
maintenance mode. The “USB Host
Connect” is displayed on the LCD.
(2) Press the or key to display
“MAINTENANCE 41” and then press
the OK key. The “Export to USB” is
displayed on the LCD.
(3) Press the or key to display the
desired restore method shown below
on the LCD, and press the OK key.
“*******.seri” is displayed on the LCD.
(“*******” shows the name of the model.)
(4) Press the OK key. The “Reboot OK?” is
displayed on the LCD.
(5) Press the OK key. “Please wait” is
displayed on the LCD and the restoring
is performed. Upon completion of
restoring, the machine returns to the
ready state.
(6) Remove the USB flash memory from
the machine.
(1) Insert the USB flash memory containing
the backup data into the slot of the
machine in the initial state of the
maintenance mode. The “USB Host
Connect” is displayed on the LCD.
(2) Press the 4 and 1 keys in this order.
The “Export to USB” is displayed on the
LCD.
(3) Press the or key to display the
desired restore method shown below
on the LCD, and press the Mono key.
“*******.seri” is displayed on the LCD.
(“*******” shows the name of the model.)
(4) Press the Mono key. The “Reboot OK?”
is displayed on the LCD.
(5) Press the Mono key. “Please wait” is
displayed on the LCD and the restoring
is performed. Upon completion of
restoring, the machine returns to the
ready state.
(6) Remove the USB flash memory from
the machine.
Note:
- Never remove the USB flash memory from the machine when exporting is in progress.
- If the serial number of the backup data saved in the USB flash memory and the serial
number of the machine do not match, the data cannot be restored.
To Next Page
Loading...
