Brother HL-L9200CDWT - Page 107

General Information
98
3
Level 1 Level 2 Level 3 Level 4 Options Descriptions
Network Wired LAN TCP/IP Boot Method
Auto* / Static / RARP /
BOOTP / DHCP
Chooses the IP
method that best
suits your needs.
IP Address ###.###.###.###
(000.000.000.000)*
1
Enter the IP
address.
Subnet Mask ###.###.###.###
(000.000.000.000)*
1
Enter the Subnet
mask.
Gateway ###.###.###.###
(000.000.000.000)*
1
Enter the Gateway
address.
IP Boot
Tries
0 / 1 / 2 / 3* / ... / 32767
Specifies the
number of
attempts the
machine will try to
obtain an IP
address when the
Boot Method is
set to any setting
except Static.
APIPA
On* / Off
Automatically
allocates the IP
address from the
link
-local address
range.
1
IPv6
On / Off*
Enables or
disables the IPv6
protocol.
Ethernet -
Auto* / 100B-FD /
100B-HD / 10B-FD /
10B-HD
Chooses Ethernet
link mode.
Wired Status -
Active 100B-FD /
Active 100B-HD /
Active 10B-FD /
Active 10B-HD /
Inactive / Wired OFF
Displays Ethernet
link status.
MAC Address - - Displays MAC
address of the
machine.
Set to
Default
Restores wired network settings of the internal print server to the
factory settings.
Wired Enable -
On* / Off
Chooses Ethernet
link mode.
The factory settings are shown in Bold with an asterisk.