Brother Homelock 1034D - Timing of the Upperlooper

-7-
 ,! -++&#+&
(A)
(OPTION)
(A) Timing of the upperlooper against the needle
1. Insert the upperlooper shaft as far as possible into the upperlooper.
2. Position the upperlooper to its extreme left position.
3. Loosen the looper lever fixing screw and position the upperlooper so that the clearance to the
pointed end to the left side of the needle is 5.6 ~ 6.0 mm.
4. Tighten the screw well.
NOTE: This clearance is for #14 needle.
www.promelectroavtomat.ru