USING FUNCTIONS BY CONNECTING THE ACCESSORY TO THE MACHINE
Getting Ready
Basic operations B-53
B
1
■ Attaching the Dual Feed Foot
a
Press the “Needle Position” button to raise
the needle.
b
Press to lock all keys and buttons.
→ The entire screen becomes white, and all keys and
operation buttons are locked.
c
Raise the presser foot lever.
d
Push the black button on the presser foot
holder and remove the presser foot.
a Black button
b Presser foot holder
→ Remove the presser foot from the presser foot
holder.
e
Use the included screwdriver to loosen the
screw of the presser foot holder, then
remove the presser foot holder.
a Screwdriver
b Presser foot holder
c Presser foot holder screw
→ Remove the presser foot holder.
f
Position the dual feed foot to the presser
foot bar by aligning the notch of the dual
feed foot to the large screw.
Side view
g
Hold the dual feed foot in place with your
right hand, then using the included
screwdriver securely tighten the large
screw.
• When attaching a presser foot, always press
on the screen to lock all keys and
buttons. You may accidentally press the
“Start/Stop” button and possibly cause injury.
• Use the included screwdriver to firmly tighten
the screw. If the screw is loose, the needle may
strike the presser foot and possibly cause
injury.
To Next Page
Loading...
Need help?
General
