GETTING READY — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
32
c
Lower the needle threader lever on the left
side of the machine, and then slowly return the
lever to its original position.
a Needle threader lever
X The thread is passed through the eye of the
needle.
z If the needle was not completely threaded,
but a loop in the thread was formed in the
eye of the needle, carefully pull the loop
through the eye of the needle to pull out the
end of the thread.
d
Raise the presser foot lever, pass the end of the
thread through the presser foot, and then pull
out about 5 cm (2 inches) of thread toward the
rear of the machine.
a 5 cm (2 inches)
X The upper threading is finished.
Now that the upper threading and the lower
threading are finished, you are ready to
begin sewing.
z If the needle is not raised, the needle
threader cannot thread the needle. Be sure
to press (needle position button) to raise
the needle before using the needle threader.
● When pulling out the thread, do not pull
it with extreme force, otherwise the
needle may break or bend.
To Next Page
Loading...
Need help?
General
