APPENDIX ————————————————————————————————————————————————————
45
When the thread is entangled
a
Turn off the machine and unplug it.
b
Remove the flat bed attachment and open the
shuttle cover at the front of the free arm. And
then look for entangled thread.
c
Cut the entangled thread with small scissors
above the needle plate and then gently
remove the thread and fabric.
d
Turn the handwheel to raise the needle, then
remove the fabric.
e
Perform steps of “Cleaning the shuttle race”
on page 39.
● If machine runs but needle does not move,
look to be sure bobbin winding shaft is
moved to the left into the sewing position.
● Do not pull or push fabric while stitching. It
may bend the needle causing it to break.
● Do not turn the handwheel and pull the fabric
by force when the thread is entangled or the
motor is locked. If the thread is entangled,
remove the thread and fabric according to the
procedure below.
● Unplug the power supply cord, otherwise
injuries or an electric shock may occur.
To Next Page
Loading...
Need help?
General
