Please read instructions from start to finish
before you start your refill.
© Zinetic.co.uk. All Rights Reserved
Carefully lower the
cartridge and bottle to
this angle and allow the
toner to settle into the
cartridge
C
Repeat stages A B C with 30 second breaks at point
C (if necessary) to allow the toner to settle into the
cartridge.
Replace the cap in your toner cartridge with the new
cap. Make sure the cap is fitted securely so that no
toner can escape.
INSTRUCTIONS FOR RESETTING THE CARTRIDGE
You have 2 options. You can either use the toner continue mode (see page 1) - or you can reset it using a
reset gear. We think the first option is the best but have provided the details for the gear reset below
Brother has introduced a small plastic gear in its cartridges that tells the printer a new cartridge is installed.
You will need to reset the plastic gear into the correct position or the cartridge will be rejected by the printer.
Follow instructions below.
Starter cartridges – (simply marked TN & come free with the
printer)
Please note that the starter cartridges (comes with a new printers) do not have the reset gear included. You
will need to purchase a reset gear.
Remove the 2 screws as shown opposite.
(if you have the orange cover fitted you will need to
remove this)
To Next Page
Loading...
