Brother MFC-8810DW - Page 63

Dialing and storing numbers
51
8
d If you want to save a fax resolution along
with the number, do one of the following:
 To store the fax resolution, press
a or b to choose Std, Fine, S.Fine
or Photo.
Press OK.
 Press OK if you don't want to change
the default resolution.
For MFC-8810DW and MFC-8910DW
(or if you downloaded IFAX and
E-mail options) 8
If you installed the IFAX and E-mail options
on the MFC-8510DN and MFC-8710DW, use
this procedure to store the Speed Dial
numbers.
a Press (Address Book) twice and
enter a three-digit Speed Dial location
number (001-300).
If a number or E-mail address is not
stored there, the LCD shows
Register Now?
Press 1 to choose Yes.
b Press a or b to choose one of the
following:
Fax/Tel
IFAX
Email Color PDF
Email Color JPG
Email Color XPS
Email Gray PDF
Email Gray JPG
Email Gray XPS
Email B&W PDF
Email B&W TIFF
Press OK.
c Enter the fax/telephone number (up to
20 characters each) or E-mail address
(up to 60 characters each). For help
entering characters, see Entering text
uu page 170.
Press OK.
Note
• If you selected an E-Mail Registration
Type in step b and save the E-mail
address, you can only use the E-mail
address when you are in SCAN mode.
• If you selected the IFAX Registration Type
in step b and save the E-mail address,
you can only use the E-mail address when
you are in FAX mode.
d Do one of the following:
 Enter the name using the dial pad
(up to 15 characters).
Press OK.
 Press OK to store the number or
E-mail address without a name.