3
e Gently put the paper into the paper tray print
side down and top edge first.
f Gently adjust the paper guides to fit the paper.
Make sure that the paper guides touch the
edges of the paper.
g Check that the paper is flat in the tray and
below the maximum paper mark a. Close the
output paper tray cover.
h Slowly push the paper tray completely into the
machine.
i While holding the paper tray in place, pull out
the paper support a until it clicks, and then
unfold the paper support flap b.
Be careful that you do not push the paper in too
far; it may lift at the back of the tray and cause
paper feed problems.
1
For printing and copying on special media, open
the manual feed slot a on the back of the
machine. Feed only one sheet at a time of A3,
Ledger, Legal, envelopes, or thicker paper when
using the manual feed slot.
For details, see Loading paper in the manual feed
slot in chapter 2 of the Basic User’s Guide.
2
1
1
To Next Page
Loading...
Need help?
General