6
4
Set your country
(Australia and New
Zealand only)
You must set your country so that the machine works
correctly on local telecommunication lines in each
country.
a Check that the power is turned on by
connecting in the power cord.
b Press your country (Australia or
New Zealand).
Press OK.
c If the LCD shows the correct country, press
Yes, and then go to step d. Or press No, and
then go back to step b and choose the country
again.
d
After the LCD shows
Accepted
for a few
seconds, the machine will restart automatically.
5
Install the ink cartridges
If ink gets in your eyes, wash it out with water at
once and call a doctor if you are concerned.
a Make sure that the power is turned on.
The Touchscreen will show
No Ink Cartridge.
b Open the ink cartridge cover a.
Make sure you install the Starter Ink Cartridges
included with your machine first.
You can adjust the angle of the control panel by
lifting it. When lowering the control panel, make
sure you push the release button a that is
located behind the mark.
1
1
To Next Page
Loading...
