15
Macintosh
USB
Windows
®
Macintosh
USB
For Macintosh USB interface users
(Mac OS X v10.6.8, 10.7.x, 10.8.x)
14
Before you install
Make sure your machine is connected to the power
and your Macintosh is ON. You must be logged on
with Administrator rights.
15
Connect the USB cable
a Lift the scanner cover until it locks securely into
the open position.
b Connect the USB cable to the USB port
marked with a symbol a. You will find the
USB port inside the machine, as shown in the
callout below.
c Carefully guide the USB cable into the cable
channel and out the back of the machine.
Connect the cable to your Macintosh.
For Mac OS X v10.6.0 to 10.6.7 users, upgrade to
Mac OS X v10.6.8 - 10.8.x.
• DO NOT connect the machine to a USB port on
a keyboard or a non-powered USB hub.
• Connect the machine directly to your
Macintosh.
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
If you have connected a telephone line, make
sure it is placed it into the cable channel first.
Press down gently on each additional cable as
you guide it through the channel.
To Next Page
Loading...
