Why does my Brother P-touch Pro PT-H111 say 'Text Full!'?
The 'Text Full!' error on your Brother Label Maker indicates that you've reached the maximum character limit, which is 80 characters for text.
Why does my Brother P-touch Pro PT-H111 say 'Cutter Pressed'?
The 'Cutter Pressed' error appears on your Brother Label Maker if the Tape Cutter Lever was pressed during the printing process.
What to do if my Brother P-touch Pro PT-H111 Label Maker says 'Text Limit! Change Length'?
If your Brother Label Maker displays 'Text Limit! Change Length', it means you've likely exceeded the set tape length. To fix this, either reduce the amount of text you're using or select the [Auto] option for the tape length setting.
Instructions on how to install the power source and tape cassette.
Guidance on how to replace a dull or damaged cutter unit for clean cuts.
Guides on inputting text, including upper/lower case and two-line formats.
Procedure to initialize settings and clear stored data.
Common error messages and their corresponding causes and remedies.
Troubleshooting steps for a blank screen upon startup.
Solutions for problems with printing or improperly formed characters.
Steps to take when the device becomes unresponsive.
Troubleshooting power issues that occur during the printing process.
Solutions for problems with tape not feeding or getting stuck.
General| Brand | Brother |
|---|---|
| Model | P-touch Pro PT-H111 |
| Category | Label Maker |
| Language | English |
To Next Page