GETTING STARTED
33
Feeding Tape
Auto Power-Off Time
Feed & Cut
The Feed & Cut function feeds 0.96" (24.5mm) of blank tape, and then cuts the tape.
Press the Feed & Cut key.
"Feed & Cut?" will appear on the LCD display.
Using the or key to select the "Feed & Cut" and then press either OK or Enter.
The message "Feeding Tape... Please Wait" appears while the tape is fed, and then the
tape is cut.
Feed Only
This function will advance the tape approximately 0.96" (24.5mm), resulting in a blank label
sticking out of the tape cassette. This action is recommended when using Fabric tapes, which
should be cut using scissors.
Setting Value Setting Value
AC Adapter Off Li-ion Battery Off
10min. 10min.
20min. 20min.
30min. 30min.
40min. 40min.
50min. 50min.
1hr. 1hr.
2hr.
4hr.
8hr.
12hr.
• If you connect the AC adapter to the P-touch labeling system after you specified "Auto Power
Off", the setting for "AC Adapter" becomes valid.
• The default value is "1hr." for the AC Adapter and "30min." for the Li-ion battery.
Feeding Tape
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the tape
cassette.
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon to
be discharged with the tape. The tape may no longer be functional after the ink ribbon
discharges.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the tape
to jam.
To exit or cancel this function press Esc.
To Next Page
Loading...
